-->

Peugeot 205 Manual

Clock - removal and refitting
Body electrical system / Clock - removal and refitting

Removal
Pre-1988 models
1 Disconnect the battery negative lead.

2 Using a small screwdriver, carefully prise the clock from its location in the facia.

3 Disconnect the clock wiring and remove the unit.

1988 models onward
4 Disconnect the battery negative lead.

5 Remove the trapezium-shaped coin compartment or cover from the top of the facia by lifting the bottom edge.

6 Pull off the heater control knobs, using card or thick cloth and pliers on the central bars.

7 Remove the screws beneath the control knobs, and withdraw the upper front panel surround.

8 Open and remove the ashtray.

9 Unclip the bottom of the clock surround and remove it.

10 Remove the oddments tray, or if fitted, the radio, as described in Section 22.

11 Remove the screws and withdraw the lower front panel surround by releasing the bottom edge first.

12 Disconnect the wiring plug from the rear of the clock, then release the clock from the lower front panel surround.

Refitting
13 On all models, refitting is a reversal of removal.


© 2024 www.peugeot205.ru. All Rights Reserved.