Removal
1 Remove the carburettor inlet cowl.

2 Unscrew the pinch bolts and disconnect the inner and outer cables from the lever and bracket (see illustration).

4.2 Disconnect the choke inner and outer cables from the lever and bracket - twin carburettor installation shown

3 Release the cable from the clips in the engine compartment.

4 Working inside the car, disconnect the warning lamp wiring and detach the cable from the support bracket.

Refitting
5 Refitting is a reversal of removal, but adjust the cable at the carburettor end so that, when the control knob is pushed fully in, the choke valve plate is fully open.