Removal
1 The door hinges are welded to the body pillar and bolted to the door.

2 Remove the plastic caps from the hinge pivot pins.

3 Drive out the roll pin from the door check strap.

4 Where applicable, remove the trim panel (Section 11) and disconnect the loudspeaker wiring from the door.

5 Support the door in the fully open position by placing blocks, or a jack and a pad of rag, under its lower edge.

6 Drive out the hinge pivot pins and remove the door.

Refitting
7 Refit by reversing the removal operations.

8 Where necessary, the striker on the body pillar may be adjusted to ensure correct closure of the door.