Removal
1 Remove the lower facia panel from the steering column in order to gain access to the pedal bracket.

2 Remove the clevis pin and disconnect the pushrod from the brake pedal. Note that on models with a vacuum servo unit the pushrod is on the lower hole, whereas the upper hole is used for models without a servo unit.

3 Unscrew the self-locking nut from the pivot bolt, pull out the bolt and lower the brake pedal. Note that on non-servo models a return spring is also fitted to the pedal.

4 Examine the pedal bushes for wear and renew them if necessary.

Refitting
5 Refitting is a reversal of removal, but lightly grease the bushes and clevis pin and renew the self-locking nut.